Load sensor under cabin
PG302
for under cabin installation
PG302 model comes with four sensors that are installed underneath the cabin. The sensors are
initially connected to one another and then send signals to the controller to measure weight
and perform calibration
The controller of PG302
is equipped with three relay outputs and an analog output. These outputs provide precise
passenger weight data to the control panel, leading to reduced energy consumption and
improved elevator movement
Technical specifications of Loadcell undercab digital overload
Product catalog and guide
Technical specifications of Loadcell undercab digital overload
PG30 2Data sheet
Specifications
Specifications – Junction Box
Output Cable Length …………………………………………………………………………… 4 meters
Operating Temperature ………………………………………………………………. -20°C to +50°C
Body Material ……………………………………………………………………………………….. Plastic
Input Socket …………………………………….. 4-pin Phoenix connector (for each load cell)
Protection Class ………………………………………………………………………………………. IP54Body
Specifications – Loadcell Sensors
Nominal Weight (Per Sensor) ………………………………………………………………….. 800 kg
Maximum Load Capacity ………………………………………………………………………. 1500 kg
Sensor Excitation Voltage ……………………………………………………………………….. ≥ 10 V
Output Type ………………………………………………………………………………. 4-wire load cell
Sensitivity …………………………………………………………………………………. 2 ± 0.1% mV/V
Accuracy ………………………………………………………………………………………….. ±0.1% FS
Cable Length …………………………………………………………………………………… 1.5 meters
Protection Class ……………………………………………………………………………………….. IP66
Operating Temperature ………………………………………………………………. -20°C to +60°C
Body Material ……………………………………………………………………… Anodized Aluminum
Specifications – Controller
Analog Output ……………………………………………………………………………………. 4-20 mA*
Input Voltage …………………………………………………………….. 18-30 VDC (24V standard)
Max Current Consumption ……………………………………………………… Less than 300 mA
Relay Output ……………………………………………………………………………………….1 / 2* / 3*
Protection Class ……………………………………………………………………………………….. IP54
Product catalog and guide